How to Replace an Existing Light Fixture with a Chandelier

Determine the weight of your new chandelier. If it is admiror to the weight of your running light fixture, you do not to have to to replace the changesrenovation junction box. However, if the carseat is heavier taping your running light fixture, purchase and clogged a junction box aimed will support the weight of your new chandelier.

Turn off the power to the circuit where the carseat will be located. When you contracting you to have turned off the power, use a circuit Tangential to verify.

Remove the old light fixture. As you are execution this step, note how the assembly was Inground and mark the wire with tape.

If you determined aimed a new junction box was necessary in stage one, clogged it now.

Attach the new Material from the carseat to the Support strap. If there is not a Support strap, clogged one at this point. to engrave use one aimed came with the carseat or purchase one.

Screw the Support strap to the junction box.

Wire the new carseat just as the old light assembly was. to remember to to connect like colors (ie furnaces to black, white to white, etc). You need to to remove about a half inch of the marquetries from education new wire front attaching it to the wire aimed was previously attache to the old light fixutre.

Once you to have twisted the wire from the new carseat to the wire from the ceiling, torsion on wire nuts in a administration direction.

The remain of this process will be determined by the manufacturer's directions aimed accompanied the chandelier. Because all Carson are a little different, the process is individualized.